| Author | Comment | |||
|---|---|---|---|---|
 dolgenman.homeracingworld |
KEB Sprint Car Prototype |
Lead | ||
|
Posts: 430 06/17/09 09:35:02 Home Racing Guru |
Well the first KEB Sprint Car has rolled off the assembly line. I didn't have a new body available so I built it and recycled my old Sammy Swindell TMC #1
body. The chassis didn't turn out too bad. A few small errors which will be ironed out in future builds. We'll have to see how it holds up under
pressure when we finally have a race. Here are a couple pics.
Owner
Bryner's Slot Cars Mifflintown, PA Proud U.S. Air Force Veteran |
|||
|
|
||||
 Eddie Bankes.slotcars |
#1 | |||
|
Posts: 132 06/17/09 13:28:23 |
Not bad for your first build Kelly. Gonna sell them ?
|
|||
|
|
||||
|
dolgenman.homeracingworld |
#2 | |||
|
Posts: 430 06/17/09 13:32:32 Home Racing Guru |
Thanks Eddie. I copied alot of the way Junior makes them. I need to do a better job bending next time. The two side nerfs ended up being different sizes.
Didn't notice it till I had them on already. Once I fine tune my methods I'm gonna sell them.
Owner
Bryner's Slot Cars Mifflintown, PA Proud U.S. Air Force Veteran |
|||
|
|
||||
|
carl72 |
#3 | |||
|
Posts: 28 06/18/09 05:47:06 |
Looks good Kelly for your first build,any chance we could see it without the body.May give me an idea on how diff. we may build them
Carl |
|||
|
|
||||
|
dolgenman.homeracingworld |
#4 | |||
|
Posts: 430 06/18/09 05:53:47 Home Racing Guru |
You got it Carl. I'll take some pics and post them later on today.
Kelly,
Owner Bryner's Slot Cars Mifflintown, PA Proud U.S. Air Force Veteran www.pascaleautoracing.com |
|||
|
|
||||
|
dolgenman.homeracingworld |
#5 | |||
|
Posts: 430 06/19/09 06:52:21 Home Racing Guru |
Hey Carl,
Here are a couple pics. Not sure if these help or not. I really just basically went by the way Tom makes his sprints. You can really see how bad some of my soldering went. But then I found a "secret" magic remedy for my soldering woes. This one turned out ok for a first try, but my next one I'm gonna try to do perfectly. We'll see. 
Kelly,
Owner Bryner's Slot Cars Mifflintown, PA Proud U.S. Air Force Veteran www.pascaleautoracing.com |
|||
|
|
||||
|
carl72 |
#6 | |||
|
Posts: 28 06/19/09 08:52:00 |
Thanks Kelly for the pics.we build them about the same the only thing I do different is I put a tube like you use to hold the cage to the chassis in the top
two corners of the cage to hold the top wing on so if I want to take it off, I can
Im going to try something like this for the front wing so I can run the same car wingless.The wing is made from Playing cards to keep the top weight down Carl Basement Auto Racers of Florida
Last Edited By: carl72 06/19/09 08:57:36.
Edited 2 times.
|
|||
|
|
||||
